• Fits in most interior and some exterior door applications
• Left and right hand units are available
• Jamb mount to push door open or door mount to pull door open.
• Inverted model, for limited room above the door
• Deep reveal and door mounted units for special applications

• Choice of 2¹/₄" square push plate on Model 4466, or 5" square push plate on waterproof, heavy duty Model 4448.
  

• Available as wired-in version with 12 feet of 2 lead wire, or as wireless type switch which does not need to be wired to operator.

• Wireless signal is coded to prevent signal duplication or frequency overlap in multiple unit installation.

• Available in surface or flush mount wall box.

• Heavy duty switch

• Supplied in push button configuration with separate wall mount

• Available as wireless type switch, or as wired version which includes 12 feed of two lead wire

• Specify surface mount wall box or flush mount

• No pressure necessary - senses the capacitance of a hand when touched.

• Stainless steel touch plate combines appearance and low maintenance.

• Low profile reduces vandalism

• No moving parts - explosion proof

• Includes 12 feet of 3 conductor low voltage wire

• Available with or without handicap emblem

• Available in surface mount switch (Model 4444S) or flush mount (Model 4444F)

• Automatic door operation for specified individuals

• 1,024 possible codes eliminates signal duplication and frequency overlap

• 1, 2 or 4 button transmitters available (Models 4440).   Can be used to provide given individuals access to different combinations of specified areas

• Transmitters require a receiver (Model 4470) to actuate door opening cycle, the receiver is mounted inside the operator

• Special transmitters with raised buttons are available

• Provide access for specified individuals

• Available as wireless or wired type switches

• Coded wireless signal

• Permits door to be secured when closed, but releases automatically when opener receives signal

• Models for metal or wooden jambs

• Silent operation

Built in Safety Features

• The operator arm is not attached to the door.  Instead, a wheel at the end of the operator arm rolls against the face of the door, pushing the door open.  
  • The door can always be opened manually from either side without involving the operator. 
  • Traffic flow is not hindered by the operator.
• The Power Access opener is always used in conjunction with a conventional manual door closer, either surface-mounted or concealed.
• Built-in load sensing circuit automatically stops the operator arm and returns to the at-rest (closed) position, if the door meets an obstruction during the opening cycle.
• Thermally protected drive motor
• Adjustable door hold-open time.